Aeg-Electrolux L87695WD Manuale Utente

L 87695 WDEN WASHING MACHINE USER MANUAL

FThe anti-crease symbol comes on when you set a dryingprogramme.GYou cannot open the appliance door when the symbol ison.You can open the door only wh

Graphic barsThe empty indicator bar appears only if the related func-tion is available for the set programme.The indicator bar fills accordingly to th

– Press two times to set 'Extra Quick' foritems with light soil.Some programmes accept onlyone of the two functions.EXTRA RINSE BUTTON 9Pres

•To deactivate the function press but-ton 8 and button 7 at the same timeuntil the symbol goes off.ENGLISH13

PROGRAMMESProgrammeTemperatureType of loadMax. weight of loadCycle de-scriptionFunctionsWASHING PROGRAMMESKatoen95° - ColdWhite and coloured cottonwit

ProgrammeTemperatureType of loadMax. weight of loadCycle de-scriptionFunctionsCentrifuge-ren / Pomp-en6)All fabrics.The spin phase assumesthe setting

5) Press EXTRA RINSE button to add rinses. With a low spin speed the appliance performsdelicate rinses and a short spin.6) To set the DRAIN programme

PROGRAMMES FOR AUTOMATIC DRYINGLevel of dryness Type of fabric LoadExtra dryFor towelling materialsCotton and linen(bathrobes, bath towels, etc)up to

CONSUMPTION VALUESProgramme Energy con-sumption(KWh)Water con-sumption(litres)Programmeduration(minutes)White Cottons 95° 2.5 73For the dura-tion of t

BEFORE FIRST USE1.To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispenser.2.Put a small quantity

CONTENTS4 SAFETY INFORMATION6 TECHNICAL INFORMATION7 PRODUCT DESCRIPTION7 ACCESSORIES8 CONTROL PANEL14 PROGRAMMES18 CONSUMPTION VALUES19 BEFORE FIRST

The detergent compartment for the prewash phase, the soak pro-gramme and for the stain function.Add the detergent for prewash, soak and stain remover

4.To use liquid detergent, turn the flapdown.With the flap in the positionDOWN:– Do not use gelatinous or thickliquid detergents.– Do not put more liq

nutes or hours. The related symbolscomes on.2.Press button 6 , the appliance startsthe countdown of the delay start.When the countdown is completed,th

USING THE APPLIANCE - DRYING ONLYWARNING!Open the water tap. Put the drain hosein the sink or connect to the drain pipe.• Load the laundry.• Turn the

• The last minutes of the drying cycle theappliance performs the anti-creasephase.The anti-crease symbol flash-es.The door is still locked.•Press butt

USING THE APPLIANCE - WASHING & DRYINGNON-STOP PROGRAMME -WASHING & AUTOMATICDRYINGCAUTION!Do not put a plastic device/ballfor the detergent i

Set drying time value• After some seconds the display showsthe total duration of the cycles:Final time value (wash-ing + drying + anti-crease + coolin

HELPFUL HINTS AND TIPSTHE LAUNDRY LOAD• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that are

Level TypeWater hardness°dH °T.H. mmol/l Clarke2 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.7 17-254 very hard > 21 > 37 >3.7 &g

CARE AND CLEANINGWARNING!Disconnect the appliance from the mainssupply before you clean it.DESCALINGThe water we use contains limescale. If itbecomes

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

DETERGENT DISPENSERTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquid ad-ditive compartment.4.Cle

To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the

129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven

When you drain the water with the emer-gency drain procedure, you must activateagain the drain system:1.Put 2 litres of water in the main washcompartm

TROUBLESHOOTINGThe start of the appliance does not occuror it stops during operation.First try to find a solution to the problem(refer to the table).

Problem Possible cause Possible solutionThe anti-flood de-vice is on. • Disconnect the appliance.• Close the water tap.• Contact the service centre.T

Problem Possible cause Possible solutionThe appliance fillswith water anddrain immediately.The end of the drainhose is too low.Make sure that the drai

INSTALLATIONFIXING PLATE KIT (405517114)Available from your authorized dealer.If you install the appliance on a plinth, se-cure the appliance in the f

5.Open the door. Remove the polystyr-ene piece from the door seal and allthe items from the drum.6.Put one of the polystyrene packagingelements on the

10.Remove the three bolts. Use the keysupplied with the appliance.11.Pull out the plastic spacers.12.Put the plastic caps in the holes. Youcan find th

SAFETY INFORMATIONBefore the installation and use of the ap-pliance, carefully read the supplied in-structions. The manufacturer is not re-sponsible

• The appliance must be level and stable.CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.THE INL

Water-stop deviceAThe inlet hose has a water stop device.This device prevents water leaks in thehose because of its natural ageing. Thered sector in t

Without the plastic hose guide.• To a sink spigot.Refer to the illustration. Put the drainhose in the spigot and tighten it with aclip. Make sure that

ENGLISH43

www.aeg.com/shop 132924160-B-122012

with a hinge on the opposite side insuch a way that a full opening of thedoor is restricted.• Fabric softener or equivalent productsmust be used as sp

• Make sure not to cause damage to themains plug and to the mains cable.Contact the Service or an electrician tochange a damaged mains cable.• Connect

PRODUCT DESCRIPTION1 2 3 8956741011121Worktop2Detergent dispenser3Control panel4Door handle5Rating plate6Drain pump7Feet for the appliance level8Water

CONTROL PANELAan/UitKatoenSyntheticaStrijkvrijFijne WasWol/Zijde20 Min. - 3 kgSpoelenCentrifugeren/PompenEcoocE repuSpotS noN.niM 06KatoenacitehtnySWo

DISPLAY 3A HCNOPD E F G ILMKB JThe display shows:AThe temperature of the set programmeCold waterBThe spin speed of the set programmeNo Spin symbol1)Ri